Macrosystem Bogart SE Ver.4 User manual Uživatelský manuál stáhnout pdf (Strana 108)

108

Appendix

both display and power saving to ‘immediately’, the Casablan-

ca will go into standby mode right away when it is switched

off. Please note that some units may not have a 0-Watt

standby operation. This also only works after a device has

been connected to the power line for at least a day. In 0-Watt

use, the display does not show the time. In addition, you can

also open the “noise management” window. This is where you

change the setting for the ‘DVD/Blu-ray unit’ in order to reduce

the noise produced by the system.

is ﬁlled out. However, the image is not simply cut off at the

sides, it remains fully visible. For this purpose, the sides are

‘squeezed’ to ﬁt. The middle section of the image remains

unchanged. Only very busy scenes or scenes with frequent

camera pans may pose a slight problem with distorted image

portions on the side. You can avoid this by choosing a differ-

ent mode.

Cinema mode:

This has an inﬂuence on the DVI/HDMi output, not on the

SCART/AV connection. Depending on whether the movie was

originally made for television or cinema, the HD signal needs

different processing to obtain a better image quality. For televi-

sion productions, the switch should be “off”, for cinema pro-

ductions it should be “on”. There is also an “automatic” option.

This way, you don’t have to switch all the time. The device

then tries to ﬁnd the best mode by itself, automatically. Please

not that the necessary information is not always transmitted

properly by the broadcaster. This may sometimes cause the

automatic function to choose the wrong mode. In such cases,

you have no choice but to switch to the correct mode yourself.

Should you not be certain, and experience somewhat annoy-

ing artefacts (particularly with television productions for which

the cinema mode has been erroneously activated), you should

switch this option to “off”.

3.3.2 Language, delay

Use these settings for movies with several sound channels.

Select your preferred language in item 1. This will be used au-

tomatically for multi-sound-channel movies. You can also set a

desired delay between sound and image, in milliseconds. This

function is useful in case your television needs more time to

construct its images than a surround ampliﬁer. You should test

several values, in case videos are not synchronous.

3.4 Connections

Depending on the device used, this is where you decide on

the format for the top SCART connection (TV). Activate either

CVBS + RGB or YC. You can also set up the bottom SCART

(Video) connection (CVBS + RGB or YC). Make sure to choose

the right setting to avoid a bad or monochrome image. If you

can’t see the picture or if the image is shown incorrectly, the

system will return to the previous mode after 10 seconds.

3.5 Device

Here, you can set up the ‘Power Saving’ mode and decide if

and when it should be activated. If your deactivate it complete-

ly (‘Never’), the device is not powered down completely when

you switch it off, but the menus become black. This has the

advantage that the unit starts up faster. You can also change

the settings for the display that is built into the device. You

can set up the display brightness modes for standby or in use

and if or when the display should be switched off. If you set up

1 2 ... 103 104 105 106 107 108 109 110 111 112

Komentáře k této Příručce

Žádné komentáře

Macrosystem Bogart SE Ver.4 User manual Uživatelský manuál Strana 108

Komentáře k této Příručce

Související produkty a manuály pro Software Macrosystem Bogart SE Ver.4 User manual