Macrosystem Akaba – New Concept Uživatelský manuál stáhnout pdf (Strana 19)

You can set the transparency of the mask with

one of the predened six gray levels. In addition,

you can modify the gray value with values of 0

to 100 using the Change Transparency button.

The following table describes how the mask

transparency is displayed according to the gray

levels.

Palette color Mask

white completely transpa-

rent, not present

gray half-transparent gray,

the mask has some

effect

black gray, the video is

completely covered

by the mask

Show BG

This button causes the drawn mask itself to

become half-transparent. This enables you to

see the video picture even behind completely

opaque regions, thus giving you the necessary

orientation when you adapt the mask to a scene.

Archive

Masks that have been created can be saved in

the archive for later use.

4. The Three Operating Modes

4.1 Draw mode

In this mode you will nd all buttons and

functions that were explained in the previous

chapter.

4.2 Retouch

This mode serves mostly for manual editing of

the individual frames of a scene. For example,

dropouts (image distortion) can be corrected.

A scene can be of any length, but you are limited

to editing a maximum of 150 half-frames (3

seconds) from the video material. These half-

frames may be at any position within the scene,

i.e. they don’t have to be contiguous.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Žádné komentáře

Macrosystem Akaba – New Concept Uživatelský manuál Strana 19